Firmware Version 01.030300 incorporates the following improvements:
- Improves fan rotation pattern to reduce fan noise when the Projector is in Power Saver Mode.
- Enables Standby mode to be identified by the Power ON LED indicator flashing at an interval of four seconds.
- Addresses an issue when the network function set to OFF (default setting). User menu settings are now retained even if the projector is turned OFF immediately after changing the menu setting.
Confirm the firmware version:
- Project a blank screen.
- Press the MENU button on the Side Control (or on the remote control) of the projector to display the menu screen.
- Use the right pointer button to go to the [Information] tab.
- Check the firmware version.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- TV / HDTV / Projectors
- COMPATIBLE WITH:
- OS Independent
- file size:
- 23.9 MB
- filename:
- PJ-WUX450-V01030300.zip