ZyXEL LTE7460-M608 Router Firmware 1.00(ABFR.1)C0

Firmware Notes:

Feature Request:
- Add MAC filter
- Add a section to display APN2 status

Bug Fixes:

- When users want to save current PIN, they should only enter the current PIN without entering new PIN as current PIN.
- Users cannot change authentication, PDP type, MTU size of the second APN settings after initial setup.
- The Internet connectivity goes down after an overnight test using an FET SIM card without much data traffic.
- Some of the small screen pages or sections are not ready, including WAN connection status, service provider’s name, signal bar, 2G/3G/4G/4G+ icon, RAN information, connected device, IPv4 IPv6 black/white filter, data usage display, SMS management.
- Users are not able to access LTE7460 using APN1 IPv6 IP address through SSH, telnet or HTTPS.
- The name "Remote management" displays incorrectly when bridge mode is enabled.

Known Issues:

- When bridge mode is enabled on APN1 while APN2 is enabled, sometimes LAN device will lose Internet connection.

Limitation:

- Login password will be reset if users downgrade the firmware to older version.

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.