Ubiquiti AF24 Radio Firmware 3.2

New Features:

- AC2 Support
- Carrier Drop tracks Capacity
- TDD Variable Duty Cycle
- Actual/Ideal receive power shown on front page
- Dataport can be disabled (please be careful)
- Displays Framelength on Front Page

Improvements:

- AirView launch defaults to download and run locally
- Improved airView interference detection time
- Bring all airFiber radios up to a common release
- Internal Cleanup/Organization

Fixes:

- Corrected Max EIRP to 23dBm for Bahrain
- Address various airView Issues including unable to start, TCP port configuration, unresponsive radios
- Modified Discovery protocol to report MAC address printed on unit

Known Issues:

- SSH password only use first 8 characters of login password
- We are investigating possible modulation downgrade relative to pre-beta code - if you see this, please let us know

Notes:

- Duplex settings MUST be the same on both Master and Slave
- Recommend updating far end of link before near end

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.