TRENDnet TEW-722BRM v1.0 Router Firmware 1.00.B14

Firmware Upgrade Procedures

1. Save the downloaded firmware file to your PC
2. Right click on the downloaded file and select Extract All or Extract Here option a. Make sure to remember the location where the extracted file will be saved.
3. Log into to the router’s configuration page (default IP is 192.168.10.1)
4. Click on the Maintenance and click on FW Upgrade.
5. Depending on your web browser, in the Upload Firmware section, click Browse or Choose File.
6. Navigate to the folder on your computer where the unzipped firmware file (.bin) is located and select it.
7. Click Apply. If prompted, click Yes or OK. Wait until the firmware upload completed and the device reboots.
8. To finalize the firmware update process you must reset the TEW-722BRM to factory default settings.
9. Log back into the TEW-722BRM, click on the Maintenance section. Under Restore Factory default click on Restore.  

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.