NETGEAR WNR2000v3 Router Firmware 1.1.2.10

Fixes:

- Updated wireless driver to support WHQL8, WPS2.0.
- Added an improvement to the WPS timeout issue.
- Fixed Bug that some client will block GUI via PIN.
- Added a check on board ID information.
- Supports SOAP 2.0.
- Disabled Router Debug mode.
- Fixed security bugs.
- Fixed [Port Forwarding] GUI should pop up message when local IP address is in the different subnet with LAN IP address.
- Fixed Bug [Netgear 141] Log --any time an external IP accesses the internal IP one log entry should be logged.
- Fixed CD-less failed issue.
- Disabled Telnet interface only in PR SKU, or GUI region is Chinese, or country code is PR.

Note:

- Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.
- The upgrade process is completed when the on screen progress bar completes. If power LED light turns amber and blinking, power cycle the router to complete the upgrade.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.