NETGEAR WC9500 Wireless Controller Firmware 4.1.0.8 CN

New Features:

- Support for WNDAP660 Access Point.
- Support for WNDAP620 Access Point.
- Support for WN370 Access Point.
- ARP Suppression.
- Multicast rate limiting.
- 300 AP standalone support.
- 'Rest of the World' country code support for WNDAP350/360/380/WNAP210/320.
- Band Steering Support.

Bug Fixes:

- Fixed for frequent wireless client reconnect for WNAP210v2.
- RFID data forwarding issue fix for WNDAP380R.
- Fixed for beacon stuck issue.
- Showing AP uptime in the UI.
- Fixed for AP reboot issues reported by WC9500 products customers.
- RFID process crash causing AP reboot fixed.
- L3 roaming fix.
- Captive Portal fix: For some instance the captive portal page is not showing up, but still the wireless clients can access Internet.
- 10G interface fix.
- Beacon interval changes.
- Fixed SNMP daemon crash issue.
- AP reboots changes ported from 7600.
- Staggering beacons changes added.
- Neighbor AP list was not sent to controller when Rogue detection was disabled.
- Changes for setting beacon interval dynamically based on the number of profiles configured for a group. Beacon interval of 320ms for groups with more than 4 profiles and 100ms for groups with less than 4 profiles.
- RFID Serial comm crash fix. Array out of bound write issue fixed.
- When more than one ACl group is present and if any one of them is with no mac
- Client IP and VLAN values getting reversed.
- Unable to configure Controller name more than 15 char.
- AP channels are not displayed properly in Monitor Access Point page.
- Fixed For memory leak during L3 roam.