Fixes:
- Fixed the issue that if queue ID other than 0 (eg. queue 2) is selected when configuring minimum bandwidth for all ports (QoS > Advanced > Interface Queue Configuration), the minimum bandwidth will be set in queue 0 instead.
- Fixed the issue that SNMPv3 Engine ID is not unique.
- Fixed the issue that the switch would lose synchronization with 802.1AS master clock occasionally when EAV is enabled.
- Fixed the issue that port 15 and 16 of GS724Tv3 would not link up after a reboot if the speed of all every port is configured to be 100M Full-duplex.
- Fixed the issue that if queue ID other than 0 (eg. queue 2) is selected when configuring minimum bandwidth for all ports (QoS > Advanced > Interface Queue Configuration), the minimum bandwidth will be set in queue 0 instead.
- Fixed the issue that SNMPv3 Engine ID is not unique.
- Fixed the issue that the switch would lose synchronization with 802.1AS master clock occasionally when EAV is enabled.
- Fixed the issue that port 15 and 16 of GS724Tv3 would not link up after a reboot if the speed of all every port is configured to be 100M Full-duplex.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Router / Switch / AP
- COMPATIBLE WITH:
- OS Independent
- file size:
- 3.8 MB
- filename:
- GS716Tv2_GS724Tv3_V5.4.2.13.zip