NETGEAR GS516TP Switch Firmware 6.0.1.16

Manufacturer:

Description

DOWNLOAD NOW

Fixes:

- Only one port works well with the time-range when apply same time-range to several ports.
- Unable to get any value from MIB object table - Dot1dTpFdbTable
- There is delay (3~6 seconds) when powering on PoE via SNMP
- IGMP Snooping querier admin mode is not saved after device reboot
- Cannot set password with special character such as "<", ">", "&", etc.
- Max number of entries in the Buffered logs file is 50 instead of 64
- Enhanced this version by adding additional PoE debug commands

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

NETGEAR GS516TP Smart Switch Firmware NETGEAR GS516TP PoE Switch Firmware NETGEAR GS516TP Firmware GS516TP Firmware NETGEAR Switch

  CATEGORY:
Router / Switch / AP
  COMPATIBLE WITH:
OS Independent
  file size:
6.7 MB
  filename:
GS516TP_V6.0.1.16.zip