MikroTik RouterOS TILE Firmware 6.48.3

MAJOR CHANGES IN v6.48.3:

- wireless - fixed all affecting 'FragAttacks' vulnerabilities (CVE-2020-24587, CVE-2020-24588, CVE-2020-26144, CVE-2020-26146, CVE-2020-26147);
- branding - added option to upload custom files (newly generated branding package required);
- console - do not clear environment values if any global variable is set;
- crs3xx - fixed Ethernet LEDs after reboot for CRS354 devices;
- crs3xx - fixed VLAN priority removal for CRS309, CRS312, CRS326-24S+2Q+ and CRS354 devices;
- crs3xx - fixed port-isolation on bonding interfaces for CRS317, CRS309, CRS312, CRS326-24S+2Q+ and CRS354 devices;
- crs3xx - improved LACP linking between CRS3xx series switches;
- crs3xx - improved system stability when receiving large frames on CPU for CRS317, CRS309, CRS312, CRS326-24S+2Q+ and CRS354 devices;
- defconf - fixed default configuration loading on RBOmniTikPG-5HacD;
- dot1x - fixed "reject-vlan-id" for MAC authentication (introduced in v6.48);
- dot1x - fixed MAC authentication fallback (introduced in v6.48);
- ipsec - fixed SA address parameter exporting;
- lte - fixed "earfcn" to band translation for "cell-monitor";
- package - added new "iot" package with Bluetooth (KNOT only) and MQTT publisher support;
- rb4011 - fixed SFP+ port MTU setting after link state change;
- rb4011 - improved SFP+ port stability after boot-up;
- route - improved stability when connected route is modified;
- sfp - improved cable length monitoring as defined per SFF-8472 and SFF-8636;
- ssh - return proper error code from executed command;
- system - improved resource allocation (improves several service stability e.g. HTTPS, PPPoE, VPN);
- tile - fixed bridge performance degradation (introduced in v6.47);
- webfig - fixed "PortMapping" button (introduced in v6.48.2);
- winbox - fixed health reporting on RB960, hEX and hEX S devices;
- winbox - show "System/Health" only on boards that have health monitoring;
- wireless - fixed issue with multicast traffic delivery to client devices using power-save;
- wireless - improved iOS compatibility with HotSpot 2.0 networks;
- www - added "X-Frame-Options" header information to disallow website embedding in other pages;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.