MikroTik RouterOS TILE Firmware 6.47.8

What's new in 6.47.8:

- arm - improved system stability;
- bgp - treat route target with AS 65535 as two byte AS;
- branding - fixed imported skin presence;
- bridge - fixed BPDU guard port disable/enable on HW offloaded interfaces;
- disk - improved disk management service stability when receiving bogus packets;
- dns - improved stability with large table of static records;
- ike1 - allow using "my-id" parameter with XAuth;
- leds - fixed LED type setting;
- metarouter - fixed directory entry reporting;
- profile - fixed process classification on x86 systems (introduced in v6.47);
- quickset - fixed wireless client "uptime" counter in "Home Mesh" mode;
- sstp - fixed "idle-timeout" on TILE and CHR devices;
- system - replace "3" in superscript to "^3" on RBD53GR devices;
- upgrade - do not try installing packages if download was not completed;
- winbox - added "operator" parameter under "Interface/LTE" menu;
- winbox - added "reformat-hold-button-max" parameter under "System/RouterBOARD/Settings" menu;
- winbox - added "tls-mode" parameter under "CAPsMAN/Security Cfg." menu;
- winbox - added "tx-rx-1024-max" counter under "Interface/Overall-Stats" for CRS3xx devices;
- winbox - do not allow MAC address changes on LTE interfaces;
- winbox - show "System/Health" only on boards that have health monitoring;
- winbox - show "System/RouterBOARD/Mode Button" on devices that have such feature;
- winbox - show "usb-bus" option on all boards that have it;
- winbox - show "usb-type" option on all boards that have it;
- winbox - sort IPv6 firewall "chain" parameter entries alphabetically;
- wireless - added support for U-NII-2 US and Canada country profiles for mANTBox series devices;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.