Softpedia >Drivers >Router / Switch / AP >MikroTik >  MikroTik RB911-2Hn Router Board Firmware 6.10

MikroTik RB911-2Hn Router Board Firmware 6.10

Manufacturer:

Description

DOWNLOAD NOW

Fixes:
- Fix autosupout.rif generation after kernel panic
- OVPN - make it work again
- OVPN client - remove cipher=any & auth=any options, protocol does not support them
- PPTP - fixed where Windows & MacOS clients were disconnecting all the time
- SSTP - make it work with Windows client with AES encryption
- IPv6 pool - fix dynamic prefix disappearing which may influence large VPNs with IPv6
- SSH client - fix key agreement when sometimes wrong DH algorithm was selected
- BGP - multipath eBGP now does not propagate BGP nexthop unless forced in configuration
- Removed 10/100 half duplex from autonegotiation advertisement on CCR

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

MikroTik 911 Lite2 Router Board Firmware MikroTik RB911-2Hn Wireless Router Firmware MikroTik 911 Lite2 WiFi Router Firmware RB911-2Hn Firmware MikroTik Router Board

  CATEGORY:
Router / Switch / AP
  COMPATIBLE WITH:
OS Independent
  file size:
11.3 MB
  filename:
all_packages-mipsbe-6.10.zip
Other versions
OS Independent