CradlePoint IBR600 Router Firmware 5.2.0

Added Support for:

- Huawei E3276 / Telus (Canada)

New features added in this release:

- Zone Firewall. Network Settings -> Firewall Configuration has been significantly changed from previous firmware versions. The most important change is the Zone Firewall implementation.
- Router services and VPN. NTP, DNS, and Enterprise Cloud Manager will all now be pushed through a VPN tunnel if ‘Router Services’ is enabled and a remote network of 0.0.0.0/0 is configured in the VPN Tunnels -> Add Tunnel -> Remote Networks page.
- Increase the maximum number of GRE tunnels from 5 to 10.
- Modem Settings: APN management enhancement, added Default Override (allows for APN entry on the modem’s default profile slot). Removed Manual option. Affects all GSM and all LTE modems, including CradlePoint and carrier-released USB modems.
- Modem Settings: Auto APN (attempt connection on assumed home carrier APN’s if default modem APN fails to connect). Added to CradlePoint GSM modem-based devices only: IBR6x0P, ARC/COR LP, ARC/COR LP2, ARC/COR LP3, ARC/COR LPE-AT, ARC/COR LPE-GN products

Additional UI/Usability changes:

- Modem Settings: Home Only (lock to home carrier). Added to CradlePoint GSM modem-based devices only: IBR6x0P, ARC/COR LP, ARC/COR LP2, ARC/COR LP3 products

Defects fixed:

- Many OpenVPN defects have been fixed
- Updated OpenSSL to version 1.0.1h

Note:

- Before upgrading to new firmware, it is always a good idea to save the configuration file from your current version. This firmware version will remove a configuration for version 3.2 or lower and will not try to keep your settings.
- Revision 5.2.0 was a significant change from previous releases. Updating from prior versions to 5.0.0 through the router UI or ECM will keep all current settings. Factory resetting 5.1.0 and then re-applying a saved configuration from a pre-5.0.0 version may not reset all saved passwords correctly. Downgrading from 5.2.0 or later to an earlier version WILL force a factory reset on the router. Saving a 5.0.0 or later configuration and applying it to an earlier version will change any non-default passwords to an unknown string.