Fixes:
- Fixed the problem of bridge mode sometimes being incorrectly detected while in auto mode.
- Fixed the problem where the SSID was not broadcast after the AirStation was awakened from eco mode with the AOSS button.
- Corrected some typos in Settings.
- Fixed the problem of bandwidth being automatically configured to 20 MHz in 40 MHz networks.
- Fixed the problem of bridge mode sometimes being incorrectly detected while in auto mode.
- Fixed the problem where the SSID was not broadcast after the AirStation was awakened from eco mode with the AOSS button.
- Corrected some typos in Settings.
- Fixed the problem of bandwidth being automatically configured to 20 MHz in 40 MHz networks.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Router / Switch / AP
- COMPATIBLE WITH:
- OS Independent
- file size:
- 4.1 MB
- filename:
- wmr300-130.zip
Other versions
OS Independent
- Newer! Buffalo WMR-300 Router Firmware 2.202016-05-13
- Newer! Buffalo WMR-300 Router Firmware 1.902015-09-10
- Newer! Buffalo WMR-300 Router Firmware 1.802015-07-16
- Newer! Buffalo WMR-300 Router Firmware 1.702015-02-11
- Newer! Buffalo WMR-300 Router Firmware 1.602014-11-06
- Buffalo WMR-300 Router Firmware 1.302014-08-08