Intel SAS Hardware RAID Driver 3.9

Supports RAID 0/1/10/5/50/6/60

Supports Intel Server Boards with optional IO Module SROMBSASMR

supports Intel RAID controllers using SAS software stack (SRCSAS18E, SRCSAS144E, SROMBSAS18E, SRCSASJV, SRCSASRB, SRCSATAWB, SROMBSASFC, SROMBSASMP2, SRCSASPH16I, SRCSASBB8I, and SRCSASLS4I)

Supports SR1625URSAS, SR2600URLX, or SR2625URLX with Activation key (AXXRAKSAS2) and RAID mini-DIMM (AXXMINIDIMM512)
This download is also valid for the products listed below. Use the links below for additional product downloads:
   
    Intel RAID Controller SRCSAS144E
    Intel RAID Controller SRCSAS18E
    Intel RAID Controller SRCSASBB8I
    Intel RAID Controller SRCSASJV
    Intel RAID Controller SRCSASLS4I
    Intel RAID Controller SRCSASPH16I
    Intel RAID Controller SRCSASRB
    Intel RAID Controller SRCSATAWB
    Intel Server Board S5000PAL
    Intel Server Board S5000PSL
    Intel Server Board S5500HCV
    Intel Server Board S5500WB
    Intel Server Board S5520HC
    Intel Server Board S5520UR
    Intel Server System SR1600UR
    Intel Server System SR1600URHS
    Intel Server System SR1625UR
    Intel Server System SR1625URSAS
    Intel Server System SR2600UR
    Intel Server System SR2600URBRP
    Intel Server System SR2600URLX
    Intel Server System SR2625UR
    Intel Server System SR2625URBRP
    Intel Server System SR2625URLX
    Intel Workstation Board S5520SC

About SATA / AHCI / RAID Driver:

When you install an operating system, SATA settings (be it AHCI, RAID, or IDE mode) are detected from the BIOS. If you want to change from one mode to another after the OS has been applied, appropriate drivers are required.

Bear in mind that if you modify these settings without installing proper files first, the operating system will not be able to boot until changes are reverted or required drivers are applied.

To perform the latter task, get the package, run the available setup and follow the instructions displayed on-screen for a complete installation. Afterwards, perform a system reboot so that all changes take effect, enter BIOS menu, and set the SATA option to the mode that best describes the newly applied drivers.

So, if you intend to modify the SATA settings to the mode described by this release, click the download button, and make the desired changes. In addition to that, don’t forget to constantly check with our website so that you don’t miss a single new release.