Features:
- Complies with USB 2.0 and USB 1.1 specifications
- Compatible with IEEE 802.3 (10Base-T) and 802.3u (100Base-TX), and T4 standards
- Single chip USB to 10/100 Mbps Fast Ethernet controller
- Embedded 20KB SRAM for RX packet buffering and 20KB SRAM for TX packet buffering
- Supports both full-duplex and half-duplex operations
- Supports suspended mode and remote wake-up (link-up or magic packet)
- Powered by USB port. No external power adapter required
- Equipped with diagnostic LEDs
- Plug & Play installation
- PHY power down mode for power saving
- Complies with USB 2.0 and USB 1.1 specifications
- Compatible with IEEE 802.3 (10Base-T) and 802.3u (100Base-TX), and T4 standards
- Single chip USB to 10/100 Mbps Fast Ethernet controller
- Embedded 20KB SRAM for RX packet buffering and 20KB SRAM for TX packet buffering
- Supports both full-duplex and half-duplex operations
- Supports suspended mode and remote wake-up (link-up or magic packet)
- Powered by USB port. No external power adapter required
- Equipped with diagnostic LEDs
- Plug & Play installation
- PHY power down mode for power saving
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Network Card
- COMPATIBLE WITH:
- Windows XP
Windows Vista
Windows XP 64 bit
Windows Vista 64 bit
Windows 7
Windows 7 64 bit - file size:
- 7.3 MB
- filename:
- EU-4207_4230Windows.zip