Chelsio T540-SO-CR Network Adapter Driver/Utility 1.24.5b0 for macOS

CHANGES:

- Upgraded firmware to 1.24.5.0
- Added support for macOS Catalina.

ERRATA (Open Issues):

- 39287: Warnings observed while installing the driver.
- 39306: Ipkts does not increment in "netstat -i" for Chelsio interfaces.
- 39322: LRO is not happening with IPv6 traffic.
- 37893: Interface receives traffic on un-subscribed multicast group.
- 37810: Interface receives traffic on only 9 multicast groups.
- 37809: Issues observed while disabling flow-control on 10G links.
- 37800: Driver reports a link bounce on toggling the interface.
- 37799: Need support to change options fields in ifconfig.
- 34906: Continous driver load/unload not supported.
- 34946: Not able to set LRO after MTU 4079.
- 5490: Man page needs to be added for cxgbtool.

About Network Adapter Drivers:

When connected, the operating system usually installs a generic driver that helps the computer to recognize the newly attached device.

However, proper software must be applied if you want to make use of all features that the network adapter has available. This task also allows computers to properly recognize all device characteristics such as manufacturer, chipset, technology, and others.

Updating the adapter's drivers and utilities version might improve overall performance and stability, increase transfer speeds, fix different compatibility problems and several network-related errors, as well as bring various other changes.

To install this release, simply get the package, extract it if necessary, run the setup, and follow the instructions displayed on-screen. When done, don't forget to perform a system restart and reconnect the network adapter to make sure that all changes take effect properly.

Without further ado, if you intend to apply this version, click the download button and install the package. Moreover, check with our website as often as possible so that you don't miss a single new release.