Rosewill RC-201 PCI SATA CARD Silicon Image RAID Driver 1.0.17.1 for Windows 7 64-bit

Features:

- PCI Interface
- Compliant with PCI Specification, revision 2.2
- Integrated PCI DMA engines
- bit, 33/66MHz fully compliant PCI host interface
- Sufficient power current 1.5A5V and 2A12V to supply External Device
- High Speed Serial ATA Interface
- Two special shielded and durable SATA1 connectors for plugging more than 1,000 times
- Dual high speed Serial ATA interface ports, each supporting 1st generation Serial ATA data rates (1.5Gb/s)
- Provides RAID 0 (Stripping) to greatly increase the performance of data transfer by simultaneously writing data to 2 drives
- Provides RAID 1 (Mirroring) to protect the data from a disk failure by writing identical data on 2 drives
- Fully compliant with Serial ATA 1.0 specifications
- Supports Spread Spectrum in receiver
- Independent 256-byte FIFOs (32 bit x 64 deep) per Serial ATA channel for host reads and writes
- HDD Controllers are capable to support all HDD sizes, but different OS may limited the HDD sizes that can be supported. For example, XP 32-bit supports only up to 2TB
- This Model supports Optical Drive (SATA CD/DVD-ROM including Blu-ray drives.)
- Please avoid using "Green" drives to build the RAID. These types of drives have slower spin up time and tend to enter power saving mode aggressively. The RAID controller would assume the drives as either dropped or damaged because of time out, and the whole RAID set will become degraded or even unusable.