Rosewill RC-200 PCI IDE Card Silicon Image ATA Controller Driver 1.0.0.0 64-bit

Follow the following instructions if you are performing a new installation of Windows XP or Windows Server 2003, and you wish to boot from a device attached to the SiI 680 Ultra-133 controller.

- Power off the system Insert the SiI 680 Ultra-133 controller into an available PCI slot Connect ATA cable(s) between the SiI 680 controller and the ATA/ATAPI device(s) Power up the system.
- Put your Windows XP or Windows Server 2003 CD into the CD-ROM/DVD drive.
- Press F6 for third party SCSI or driver installation at the beginning of text mode installation Press 's' when setup asks if you want to specify an additional device, and insert the diskette labeled 'Silicon Image ATA/133 Driver Installation Disk' and press 'Enter'.
- From the menu presented next, select the SiI 680 driver that matches the system's processor type and press 'Enter'.
- Press 'Enter' again when prompted to continue on with text mode setup.
- Follow the setup instructions to select your choice for partition and file system.
- After setup examines your disks, it will copy files from the CD to the hard drive selected above and restart the system After restart the setup process will resume to finish the installation.
- Once the operating system installation has completed you can follow the instructions in section 4 to verify controller was installed correctly.