OCZ Toolbox Firmware Updater 3.02.12 / Vertex 4 and Agility 4 SSD Firmware 1.4.1.3

Updating the firmware from the toolbox is not supported when Windows is running off the drive you are trying to update.

WARNING:

This is NOT a Destructive Flash for firmware version 1.4 and newer. This is a Destructive Flash for firmware version 1.3 & 1.4RC, back up all data on SSD. Proceeding with this update will result in complete loss of data on the SSD.

WARNING:

This is a two step firmware update process.
1. Run OCZ Toolbox. Toolbox will update firmware to 1.4.1.2 first.
2. Shutdown and restart the system.
3. Run OCZ Toolbox again, Toolbox will now update firmware to 1.4.1.3.

This completes the firmware update.
-Toolbox will not update a primary system drive (e.g. drive letter "C:"). You must run Windows from another drive and then update your SSD using Toolbox.

Improvements since version 1.4:

- Enhancement: Improved RAID card compatibility.
- Fixed: Corner case issue where drive would not resume from S3/S4 properly. 
- Fixed: Rare issue where some platforms would not respond correctly after a cold boot.