Fixes:
This version of the tool contains a firmware update for the Intel SSD 530 Series (to version DC32) with the following changes:
- Default Software Settings Preservation (SSP) for DIPM is changed from a default = on, to a DEFAULT = OFF. This addresses situations in older systems where the drive was not found after a warm reset causing blue screens.
- Corrects an occasional miss-reporting of SMART attribute E3h (Timed Workload Read/Write ratio).
- The drive no longer increments SMART 0Ch (Power Cycle Count) after a SECURE ERASE operation.
This version of the tool contains a firmware update for the Intel SSD 530 Series (to version DC32) with the following changes:
- Default Software Settings Preservation (SSP) for DIPM is changed from a default = on, to a DEFAULT = OFF. This addresses situations in older systems where the drive was not found after a warm reset causing blue screens.
- Corrects an occasional miss-reporting of SMART attribute E3h (Timed Workload Read/Write ratio).
- The drive no longer increments SMART 0Ch (Power Cycle Count) after a SECURE ERASE operation.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- HDD / SSD / NAS / USB Flash
- COMPATIBLE WITH:
- Windows XP
Windows Vista
Windows XP 64 bit
Windows Vista 64 bit
Windows 7
Windows 7 64 bit - file size:
- 40.1 MB
- filename:
- Intel SSD Toolbox - v3.2.0.exe
Other versions
Windows 10
Windows 10 64 bit
Windows 8.1
Windows 8.1 64 bit
Windows 8
Windows 8 64 bit
Windows 7
Windows 7 64 bit
Windows Vista
Windows Vista 64 bit
Windows XP 64 bit
Windows XP
Windows 2008
Windows Server 2012