Buffalo TS3200D NAS Firmware 1.12

Fixes:
- In some cases, a failed firmware update could repartition the drive(s), possibly leading to loss of user data. This problem has been resolved; the system will no longer replace user partitions. After recovery, user partitions will still be undamaged and available.

How to Update:

- Connect the TeraStation to the computer that will run the updater, and make sure both devices are on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.
- Exit all applications. Also, disable or exit any firewall software. You may resume firewall after the update is complete.
- Extract the downloaded file and run TSUpdater.exe. When a TeraStation is detected, an update window will open.
- If multiple TeraStation units are connected, select which unit to update.
- Click 'Update' and enter the TeraStation's admin password.
- Click 'OK'.
- The firmware will begin updating. The info LED will flash during the update process.
- When update is complete, a message will appear.

Notes:

- Do not turn the unit or the hub off until the update is finished.
- The update will take several minutes. If it times out after 10 minutes or more, reboot the TeraStation and try again.
- Do not access your TeraStation while updating firmware.
- If the firmware update fails due to inconsistent wireless connectivity, connect your PC via a wired connection, then try again.
- Update may fail if the computer updating the firmware has multiple network interfaces enabled. Disable any unnecessary network interfaces and try again.
- USB drives are not mounted automatically after a firmware update. Unplug and then reconnect them after the update.