Fixes:
- When I activated one profile the rate is 144 and the rate will become 300 right away after I activated two profiles.
- Time interval issue in Beacon. The beacon interval is increased by VAP number.
- 2.4G doesn't work well after 20+ STA links.
- U11 power saving issue - disconnection of SIP phone.
-WPA-PSK support in WDS.
- Can use [Space] in SSID string
- Mail log issue. It can’t send mail log and clear log when log is full.
- Remove “Universal” from repeater setting
- Get wrong subnet mask under DHCP mode.
- When I activated one profile the rate is 144 and the rate will become 300 right away after I activated two profiles.
- Time interval issue in Beacon. The beacon interval is increased by VAP number.
- 2.4G doesn't work well after 20+ STA links.
- U11 power saving issue - disconnection of SIP phone.
-WPA-PSK support in WDS.
- Can use [Space] in SSID string
- Mail log issue. It can’t send mail log and clear log when log is full.
- Remove “Universal” from repeater setting
- Get wrong subnet mask under DHCP mode.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 6.6 MB
- filename:
- NWA1121-NI_2.00(AABJ.0)C0.zip
Other versions