Yamaha SP2060 Processor Firmware 1.32

Improvements

- If the power is turned off within 5 seconds after modifying a parameter or during store/recall of a scene, backup of data is interrupted and in some cases internal data may be corrupted. In such cases with previous versions, when the power is turned on, "Scene Recall Err" was displayed, and a scene recall operation by the user was required. In this version the last scene used before turning off the power is recalled automatically, and operation by the user is unnecessary.
- The detection accuracy of the backup battery voltage was improved.

Important Notice

- The hardware specification for DME Firmware V3.5x or earlier differs from the one for Firmware V3.8x or later. Therefore firmware V3.5x or earlier cannot be upgraded to V3.81 or later. Also, firmware V3.81 or later cannot be downgraded to V3.5x or earlier. (This does not apply to the SP2060 or ICP1.)
- If you need to upgrade your DME from V3.55 or earlier to V3.81 or later, please contact your Yamaha dealer.
- Save an up-to-date DME project file (.daf). Don't update unless an up-to-date ".daf" file has already been saved on your computer. Without the ".daf" file, you will not be able to restore DME operation.
- When DME64N/24N units running firmware version 3.5x or earlier and DME64N/24N or DME Satellite units running firmware versions 3.81 or later are combined in the same device group, DME64N/24N units running firmware version 3.5x or earlier cannot be designated as the group master.