VIA Labs VL810 / VL811 Controller Utility 0.41 / Firmware 0.89 Beta
Firmware Release Notes:
Release number: 0008_9 BETA
- USB 3.0:
1. Code consolidation
- USB 2.0:
1. Fixed an issue that occurred when VL810 was connected downstream to particular Charger ICs during S3/S4, where VL810 would initiate remote-wake after Charger IC toggled Vbus.
NOTE:
This is a BETA firmware release for testing purposes only. BETA FW have not been fully validated so test-report data is unavailable. If you experience issues with this BETA FW, please contact your VIA Labs representative.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- Windows XP
Windows Vista
Windows XP 64 bit
Windows Vista 64 bit
Windows 7
Windows 7 64 bit - file size:
- 712 KB
- filename:
- Usb3HubFWUpgrade_Setup_V0.41_VL810_0890.zip