Fixes:
- Pairing in Bolt utility supports European/International Bolts
- If connection failed during pairing, all subsequent connection attempts would fail
Note: this firmware applies for the following:
- Bolt Pro SDI models only
- Hardware revisions
- TX – Rev. F or later, serial numbers 72001000 and up
- RX – Time Code support – Rev. C or later (serials 72501000 and up)
- RX – Fan Control support – Rev. E or later (serials 72501600 and up)
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- Windows All
- file size:
- 44 KB
- filename:
- Teradek_Bolt_Utility_v2.0.3_WIN.zip