TRENDnet TEW-735AP (Version v1.0R) Access Point Firmware 1.02
Installation notes:
- Right click on the downloaded file and select Extract All or Extract Here option. Make sure to remember the location where the extracted file is saved will be saved.
- Log into the TEW-735AP by typing http://tew-735ap or the IP address. The default IP address of TEW-735AP is 192.168.10.100
- Click on Management and then Firmware Upgrade
- Click Browse... and navigate to the folder on your computer in which the unzipped firmware file (.bin) is.
- Located and select it the firmware file.
- Click Apply.
- Wait until the firmware upload completed and the device reboot.
- The firmware upgrade is completed.
- Reset to Factory Default Settings
Note
:
Not all the configuration files can be carried over to different versions of firmwares. It is recommended that you reset configurations to factory default and configure you TEW-735AP from the fresh start again.
To reset TEW-735AP configuration back to factory default, click Reset in this page. All configurations will be set back to its original default settings.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 3.2 MB
- filename:
- fw_tew-735ap(1.02).zip