Netgear WGR614v6 Firmware 1.0.11

NETGEAR has been a worldwide provider of technologically advanced, branded networking products since 1996. Our mission is to be the preferred customer-driven provider of innovative networking solutions for small businesses and homes.


Fixes

1. Router does not reboot under heavy traffic.
2. DHCP client now renews after lease expires.
3. Fixes German ISP PPPoE.

To Upgrade

Be sure to follow Steps 4 and 12, as described. It may seem they can be avoided, however this may cause performance or other problems later.

1. Open a Web browser.
2. Access the router (http://192.168.1.1 or the Default Gateway address if the router's default IP was changed).
3. Log in the router (User Name = admin and Password = password, unless you changed it).
4. Write down all settings that you entered when previously configuring. (Usually this includes information such as ISP configuration and wireless security settings.)
5. Download the file from the North America or non-North America link below.
6. Under Maintenance, click Router Upgrade
7. Click Browse and locate the firmware upgrade file.
8. Click Upload.
9. Wait for the router to reboot.
10. Under Maintenance, click Settings Backup, then click Erase. (Or press the reset button on the back for 10 seconds.)
11. Wait one minute for the router to reboot.
12. Manually enter the configuration information you wrote down in Step 4. Use the Smartwizard, or manually configure as shown in the box below.

If the router has problems, repeat the whole procedure, Steps 1-12.