Jeti DC-16 RC Transmitter Firmware 3.02

New features:

- Possibility to set the output of the internal connector to 16-channel PPM format (see the
menu System→ Configuration. Suitable for use with an external RF module.
- The possibility of asymmetric free mixes, e.g. mix output for each servo can be adjusted separately both for positive and negative throws. The Mix output parameter can be easily used to adjust the differentiation for the ailerons to flaps mix and others.
- Ability to reset the selected timer using the transmitter control has been added (menu Timers/Sensors → Timers). From now on it is not necessary to activate the Clr button in the main screen. When pushing the Reset switch, the timer is immediately set to the initial value.
- Now it is possible to set the threefold repetition of alarm messages from the sensor. In the Timers/Sensors → Alarms menu create a new alarm, highlight "Repeat" and press the 3D button twice.
- The editing form of dual and exponential rates has been improved – automatic selection of edited parameter depending on the position of the control has been added. Furthermore, the possibility of asymmetric rates for rudder and ailerons has been added. After highlighting and unchecking “Symmetric DR”, then pushing the F(4) Sym. button it will be possible to adjust the aileron rates to the right and left independently.
- A new language: Spanish (currently without the voice output support).

Modifications:

- The data analysis from the SD card records reads correctly the records of all models regardless of the models´ names.
- Correct display of the current free mix value when editing its properties.
- The operation with the internal SD card has been improved.
- The support for setting the MBar EX sensor via Device Explorer has been added.
- Additional security question when selecting wrong model has been added.