Fixes:
- When RedNet 6 SRC was clocked to Word Clock input, corrupt MADI data could be transmitted
- RedNet 6 does not retain clock source selection on power cycle
- When RedNet 6 SRC was clocked to Word Clock input, corrupt MADI data could be transmitted
- RedNet 6 does not retain clock source selection on power cycle
To update RedNet 6 firmware, follow these instructions:
- Launch RedNet Control
- Right click on the virtual RedNet 6 device panel
- Select Firmware Update...
- Choose the downloaded file: "RedNet 6 Firmware 582.dnt"
- Wait for firmware update process to complete. Do not switch off or disconnect the device.
- After firmware flashing is complete, the unit will reboot
- The unit will now be updated and ready to use
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 5.1 MB