Agilent Technologies 34460A Digital Multimeter Firmware 1.09

Fixes:

1. Reduces DMM boot time from ~ 50 seconds to < 30 seconds.
2. Adds a query which returns the DMM power on duration since the last power cycle. This is accessed
from the front panel by pressing:
Shift - Utility - Test/Admin - Calibrate - Show Uptime
or by sending the command: SYSTem:UPTime?
3. Adds the ability to turn off the key “click” when a front panel key is pressed. This is accessed from the front panel by pressing:
Shift -Utility -System Setup -User Settings -Sounds -Key Click (Off/On)
or by sending the command:
SYSTem:CLICk:STATe (OFF/ON)
4. Now displays the current level associated with diode measurements.
5. Resolved a defect such that a wildcard (*) used with MMEM: or MMEM:DEL now operates in the
same manner.
6. Resolved a defect such that sending a Device Clear while *TST? or TEST:ALL? is in progress no longer locks up the instrument. 2
7. Resolved a defect such that sending a Device Clear while a self-test in in progress no longer causes
-310, “System error” and/or self-test failed errors.
8. Modified the message regarding changes to the DMM’s LAN Services to avoid confusion. For new
service settings to take effect, press:
Done -Apply Changes
and then cycle power.
9. Resolved a defect such that DISPlay:VIEW TCHart will now display data independent of the
CALCulate:AVERage:STATe setting.
10. Resolved a defect such that DATA:REMove? No longer intermittently generates -230, “Data corrupt or stale” errors when sufficient readings are available.
11. Resolved a defect such that selecting Default Preferences from the front panel:
Shift -Utility -Store/Recall -Set to Defaults -Default Pref
now sets the default ‘Easy File Access’ setting (OFF).