Fixes:
- Fixed IPsec, PPTP, and L2TP Passthrough
- Corrected issue such that log entries are not flushed after sending log
- Fixed UI bugs in router status page
- Corrected issues with RIP
- Fixed Ethernet driver lock up issue if port is flooded during power up
- Fixed issue where setup wizard is able to detect as DHCP connection but can't establish internet connection by selecting APPLY or TEST button.
- Fixed issue with not able to reset to factory default sometimes.
- Disabled traffic meter per request from Comcast
- Fixed SNMP to allow access from WAN side.
- Fixed IPsec, PPTP, and L2TP Passthrough
- Corrected issue such that log entries are not flushed after sending log
- Fixed UI bugs in router status page
- Corrected issues with RIP
- Fixed Ethernet driver lock up issue if port is flooded during power up
- Fixed issue where setup wizard is able to detect as DHCP connection but can't establish internet connection by selecting APPLY or TEST button.
- Fixed issue with not able to reset to factory default sometimes.
- Disabled traffic meter per request from Comcast
- Fixed SNMP to allow access from WAN side.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 2.8 MB
- filename:
- WNR1000-2VCNAS Firmware Version 1.0.0.12.zip
Other versions