Fixes:
- The Product Registration feature is supported. It will guide user to register Netgear switch when user login the switch through GUI first time.
- The user's MAC is not added into vlan assigned by radius when "dot1x port-control mac-based" enable
- Somehow during boot up, GSM7248v2 reports TFFTS error on the console
- FAN Failure message are shown in GSM7224v2.
- Device hangs during the second SSH connection to GSM7224v2.
- CPU is very busy when it is idle
- 'monitor session 1 source interface cpu' doesn't work on GSM7224v2
- GUI: fail to download config file through HTTP on GSM72xxv2
- GSM7248v2 shows Error when enabling 802.1x through GUI
- The Product Registration feature is supported. It will guide user to register Netgear switch when user login the switch through GUI first time.
- The user's MAC is not added into vlan assigned by radius when "dot1x port-control mac-based" enable
- Somehow during boot up, GSM7248v2 reports TFFTS error on the console
- FAN Failure message are shown in GSM7224v2.
- Device hangs during the second SSH connection to GSM7224v2.
- CPU is very busy when it is idle
- 'monitor session 1 source interface cpu' doesn't work on GSM7224v2
- GUI: fail to download config file through HTTP on GSM72xxv2
- GSM7248v2 shows Error when enabling 802.1x through GUI
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 7.2 MB
- filename:
- gsm72xxv2-V8.0.1.36.zip