NETGEAR DGND3300v2 Router Firmware 2.1.00.53 DE

Manufacturer:

Description

DOWNLOAD NOW

Fixes:
- Added support for up to four VPN passthrough sessions.
- Added support for Schedule-based Wi-Fi On/Off. To invoke this feature go to the Advanced Wireless Settings and check "Turn off wireless signal by schedule" then set the schedule. Please note this feature requires an Internet connection for NTP time sync.
- To reduce possibility of errors with the Internet Service Provider password the password is now left in clear text during entry and after being applied.
- Added support for Internet Explorer 9.
- Fixed a problem where in some cases Attached Devices were incorrectly detected as UNKNOWN devices.
- Fixed a problem with a particular Internet Service Provider which could result in repeated Internet disconnections.
- Fixed a problem where router PIN (used with Wi-Fi Protected Setup) could not be disabled.

  It is highly recommended to always use the most recent driver version available.

Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.

NETGEAR DGND3300v2 Wireless Router Firmware NETGEAR DGND3300v2 WiFi Router Firmware NETGEAR DGND3300v2 ADSL2+ Modem Firmware DGND3300v2 Firmware NETGEAR Router

  CATEGORY:
Firmware
  COMPATIBLE WITH:
OS Independent
  file size:
11.4 MB
  filename:
DGND3300Bv2_V2.1.00.53_1.00.53.zip