Fixes:
- Change adsl driver to 4.8.0, datapump to 4.5.0.12.0.1
- Static Route: the default route is advertised with metric =0.
- WAN Setup: the default MTU is not right.
- Basic settings: click test button should not disconnect internet connection.
- Setup wizard: when network type is PPPOA, running auto detect, after detect PPPOA, the login name is not blank but Guest.
- GUI: in the head of GUI, it displayed N300 Wireless router, but the maximum wireless mode is up to 270Mbps, not 300Mbps.
- RIP: When DUT's RIP set as RIP-2M, BOTH direction, but DUT still learn RIP-1 routes from other RIP-1 router.
- Change adsl driver to 4.8.0, datapump to 4.5.0.12.0.1
- Static Route: the default route is advertised with metric =0.
- WAN Setup: the default MTU is not right.
- Basic settings: click test button should not disconnect internet connection.
- Setup wizard: when network type is PPPOA, running auto detect, after detect PPPOA, the login name is not blank but Guest.
- GUI: in the head of GUI, it displayed N300 Wireless router, but the maximum wireless mode is up to 270Mbps, not 300Mbps.
- RIP: When DUT's RIP set as RIP-2M, BOTH direction, but DUT still learn RIP-1 routes from other RIP-1 router.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 8.3 MB
- filename:
- DGN3500-V1.1.00.30_NA.zip