Known Issues:
- When managing the unit remotely the management interface takes too long to show up (about forty seconds).
- A supported 3 terabyte USB hard drive may take up to a minute to attach.
- When the DGN2200v3 has a fixed IP address the Attached Devices (under the Maintenance menu) will not show up correctly.
- In Attached Devices some wireless devices may show up as wired.
- There is an issue with Wi-Fi Protected Setup (WPS) with the WN111v2 wireless client.
- When managing the unit remotely the management interface takes too long to show up (about forty seconds).
- A supported 3 terabyte USB hard drive may take up to a minute to attach.
- When the DGN2200v3 has a fixed IP address the Attached Devices (under the Maintenance menu) will not show up correctly.
- In Attached Devices some wireless devices may show up as wired.
- There is an issue with Wi-Fi Protected Setup (WPS) with the WN111v2 wireless client.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 16 MB
- filename:
- DGN2200v3 Initial Firmware Version 1.1.00.10 (North America).zip
Other versions
OS Independent
- Newer! NETGEAR DGN2200v3 Router Firmware 1.1.00.25 WW2015-06-10
- Newer! NETGEAR DGN2200v3 Router Firmware 1.1.00.25 DE2015-06-10
- Newer! NETGEAR DGN2200v3 Router Firmware 1.1.00.25 NA2015-06-10
- Newer! NETGEAR DGN2200v3 Router Firmware 1.1.00.24 WW2014-06-28
- Newer! NETGEAR DGN2200v3 Router Firmware 1.1.00.24 DE2014-06-28
- NETGEAR DGN2200v3 Router Firmware 1.1.00.10 (NA2013-09-24
- NETGEAR DGN2200v3 Router Firmware 1.1.00.23 (WW2013-09-23
- NETGEAR DGN2200v3 Router Firmware 1.1.00.23 (DE2013-09-23