Klipsch HD Wireless Speakers Firmware 10.5.12

SUMMARY OF UPDATES:

- Low-Volume Bass Boost added
- Power Save Mode added
- HDMI Standby Pass-Through added
- Smoother Setup Guide experience
- Bass management performance tweaks
- Enhanced update process
- Stability fixes
- Cosmetic improvements

To update your firmware:

- Unzip the firmware .zip file, and copy the ".bin" file over to a USB drive.
- Power on the HD Control Center. Insert the USB drive into the "Service" port in the rear after it has booted up fully.
- A message should appear on the screen. Confirm the update by selecting "Yes".
- The front panel LEDs will flash in a pattern to signal activity during the
update process.
- The HD Control Center may reboot at some point - this is expected.
- Once the update is complete, the hub will return to normal.

The update will take somewhere between 5 to 30 minutes, depending on how many speakers you have in your system.

FEATURES

Adjust sound - Low volume bass boost
• Feature added
Status - speaker
• Improved information on speaker version and update handling
Status - firmware
• Linux and application version displayed
Advanced
• Power save mode control added
• HDMI pass through in (pseudo) standby added
Firmware update
• Improvements in displayed status during update process
Remote control codes
• Full set implemented
Other
• Improved CEC handling for certain TVs

BUG FIXES - MAJOR

Guided setup
• Better handling of non-standard speaker configurations.
Adjust sound - speaker levels
• Corrected levels played in sub and sub now correctly muted for non-sub level check
Adjust sound - subwoofer placement
• Corrected sub gain based on setting
Adjust sound - Audio enhancement
• Corrected bass boost in night mode and when switching modes
Advanced - Advanced speaker actions
• Improvements in handling move/add/remove for non-standard cases
Speaker update
• Handle cases where speaker flashwriter needs a special update before updating speaker software.
Speaker changes during operation
• Better handling of playback format speaker changes
USB sticks with no partition table
• Added ability to handle a wider range of USB sticks
Factory reset
• Occasional failures to restart after reset corrected
• Correct defaults set after reset
AC3 stream "PAUSE"
• Correctly mutes now

BUG FIXES - MINOR

Speaker LED status during updates and chime
• Hub correctly control speaker LED option (some features require updates
speaker software)
OSD
• Various cosmetic improvements
OTHER
• Smoother sample rate transitions 

About Speaker Firmware:

Install this firmware and your speaker can receive new configuration options, improved sound quality, different fixes for issues encountered throughout the speaker’s lifetime, and other changes that can enhance its stability and compatibility.

However, before downloading this version, make sure that your speaker unit could use the modifications that are to be made with it. Don’t get the new firmware if that’s not the case.

Since there are countless models and manufacturers, as well as different methods for updating the speaker unit, it would be best if you read and understand the installation steps before initiating the update process.

In addition to that, we recommend you perform the installation in a steady power environment, such as the one ensured by a UPS unit so that the device doesn’t encounter any malfunctions.

Therefore, if you wish to apply this version, click the download button, and install the package. Also remember to check with our website as often as possible so that you don’t miss a single new release.