Fluke 1735 Three-Phase Power Logger Firmware 1.10.5370

Fluke 1735 V1.10 Release notes

- Show +/- Energy in POM measure, show totalized Energy also. 
- Bug fix for 6kA iFlex set, Powerlog (previously showed only 50% amps readings). 
- Bug fix when Returning from Setup with changed amps range into hold mode showed wrong results. When changing to run mode, changes were propagated and showed correct results. 
- Bug fix for wrong message shown when turning the rotary switch in record:hold mode.

About Device Firmware:

Applying a newer firmware version than the one already installed on your unit can bring various enhancements, include workarounds for diverse problems encountered by the device, and improve or add newly developed features.

On the other hand, downgrading the firmware version can recover the device’s functionality in the event of a software update either turning up faulty or causing the unit’s overall performance to drop. However, bear in mind that applying an older firmware isn’t recommended and might not always be possible.

When it comes to the update steps, due to the large variety of devices and numerous ways for installing a new firmware, it is recommended that you carefully read and understand the upgrade steps, and consider applying a different firmware only when you have familiarized yourself with the update method.

As the installation process is most of the times quite risky, this step should be taken by users that have the ability to successfully complete the update; regular users may initiate it at their own risk. Moreover, it’s best that this task be performed in a steady power environment such as the one ensured by a UPS unit.

Therefore, if you consider applying this release, hit the download button, take into account all the aforementioned aspects, and update the device’s firmware. Also make sure you constantly check with our website to ensure that you don’t miss a single new release.