Engenius ESR300H Router Firmware 1.1.3.14

Specifications:

Hardware Specifications
Physical Interface
- Antenna Connector
- Power Jack
- LAN: 10/100 Ethernet RJ45
- WAN: 10/100 Ethernet RJ45
- Power Switch
LED’s Status
- WPS (Press 1-to 5 seconds to activate the router’s Wi-Fi Protected Setup (WPS) feature.
- (Press 6-to-10 seconds to reboot the router)
- (Press up to 20 seconds to reset the router to factory default)
- Power Status

WAN Internet Connection
LAN LAN1 – LAN4
WLAN Wireless Connection

RF Specifications
- Frequency Band 2.400 – 2.484 GHz
- Modulation Technology
- OFDM: BPSK, QPSK, 16-QAM, 64-QAM
- BPSK, DQPSK, CCK
- Operation Channels 11 for North America, 13 for Europe, 14 for Japan
- Receive Sensitivity
- (Optimal) -90 dBm
- Available Transmit Power (Optimal) 23dBm
- Antenna 2 detachable 2 dBi

Software Features
- Router and Gateway
- Operation Mode AP / Router / WDS

LAN
- DHCP Server
- Static Routing Table
- UPNP

WAN Static IP, Dynamic IP, PPPo, PPTP, L2TP

Router
- NAT / NAPT
- Static Routing-RIPv2
- Dynamic Routing
- Virtual Server Mapping
- IP address Mapping
- Port Forwarding
- Port Triggering
- MAC Address Filtering
- ALG (Application Layer Gateway) Support

Firewall
- Block ICMP
- SPI (Static Packet Inspection)
- DoS Attack Blocking
- Rule Based (IP Address Ranges, Port Ranges &
- Schedule)
- DMZ (Demilitarized Zone) Host Support

Parental Control
- Time Based Internet Access Control
- URL / Keyword Filtering

VPN
- L2TP & PPTP VPN tunneling
- VPN pass-through (PPTP, L2TP, IPSEC)

Wireless
- WEP
- WPA
- WPA2
- 802.1x Authenticator
- Hide SSID in beacons
- WPS
- Auto Channel Selection
QoS WMM

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.