EnGenius EAP350 Access Point Firmware 1.1.0

HARDWARE SPECIFICATIONS:

MCU/RF: AR7242 + AR9283
Memory: 32MB
Flash: 4MB
Physical Interface: LAN:
1 x 10/100/1000 Gigabit Ethernet RJ-45
Reset Button
Power Jack
LEDs Status
Power/Status
LAN (10/100/1000Mbps) 
WLAN (Wireless connection)

Power Requirement: 

Power Supply: 90 to 240 VDC ± 10%, 50/60 Hz
Active Ethernet (Power over Ethernet, IEEE802.3af)
48 VDC/0.375A
Device: 12V/1A

RF Specifications

Wireless Standard: IEEE802.11 b/g/n
Frequency: 2.400 ~ 2.484GHz (b/g/n)
Modulation Technologies: OFDM: BPSK, QPSK, 16-QAM, 64-QAM
DBPSK, DQPSK, CCK
Operating Channels: 11 channels

Transmit Power:

802.11b(2.412 ~ 2.472 GHz)
29 dBm @ 1Mbps
29 dBm @ 2Mpbs
29 dBm @ 5.5Mbps
29 dBm @ 11Mbps

802.11g(2.412 ~ 2.472 GHz)
29 dBm @ 6Mbps
29 dBm @ 9Mbps
28 dBm @ 12Mbps
28 dBm @ 18Mbps
24 dBm @ 24Mbps
24 dBm @ 36Mbps
23 dBm @ 48Mbps
23 dBm @ 54Mbps

802.11n(2.412 ~ 2.472 GHz)
26 dBm @ MCS0/MCS8
26 dBm @ MCS1/MCS9
25 dBm @ MCS2/MCS10
25 dBm @ MCS3/MCS11
24 dBm @ MCS4/MCS12
24 dBm @ MCS5/MCS13
23 dBm @ MCS6/MCS14
23 dBm @ MCS7/MCS15

Receiver Sensitivity:

802.11b (2.412 ~ 2.472 GHz) best ≤ -98 dBm
802.11g (2.412 ~ 2.472 GHz) best ≤ -93 dBm
802.11n (2.412 ~ 2.472 GHz) best ≤ -93 dBm
Antenna: Embedded omnidirectional antenna (Diversity support)
Antenna Gain = 5 dBi 

Software Specifications

Topology: Infrastructure/Ad-Hoc
Operation Mode: Access Point/WDS/Repeater
Multiple BSSID: Supports up to 4 BSSIDs
LAN IP (check validity and DHCP server IP range)
MAC
DHCP range, lease time, client list
VLANs: Supports 802.1q (up to 4 VLANs)
SSID to VLAN mapping
Spanning Tree: Supports 802.1d Spanning Tree Protocol
Wireless mode: 11b/11g/11n
Channel selection (setting varies by country)
Channel bandwidth (Auto, 20MHz, 40MHz)
Transmission rate: 11n only, 11b/g/n mix, 11b only, 11b/g, 11g only
VPN: VPN pass-through (PPTP, L2TP, IPSEC)
QoS: WMM
WPS: Software only
Security: 
WEP Encryption - 64/128 bit
WPA Personal (WPA-PSK using TKIP or AES)
WPA Enterprise (WPA-EAP using TKIP)
802.1x Authenticator 
SSID broadcast enable/disable
MAC Address Filter (AP mode)
WLAN L2 isolation (AP mode)
Wireless STA (Client) connected list (Idle/Connection Time, Pkt statistics)

Management

Tx Power Control: Adjust transmit power by dBm
Configuration: Web-based configuration (HTTP)/Telnet
Telnet Server: CLI
Firmware Upgrade: Upgrade firmware via web browser 
Administrator Setting: Administrator Username & Password change
Reset Setting:
Reboot (press 1 second). Reset to Factory Default (press 10 second)
System Monitoring: Status Statistic and Event log
SNMP V1 , V2c
MIB: MIB I , MIB II(RFC1213) and Private MIB
Traffic Measurement: Per interface
Auto-channel Selection: Automatically selecting least congested channel
Bandwidth Measurement: IP range and bandwidth management
Backup & Restore: Save & restore settings through Web interface
Diagnosis: IP pinging statistics 

Environment & Physical

Temperature Range: 
Operating: 0 to 50° C (32° to 122° F)
Storage: -20 to 60° C (-4° to 140° F)
Humidity (non-condensing): 
Operating: 90% or less
Storage: 90% of less 
Dimensions:
Diameter: 4.73” (120mm)
Height: 1.97” (50mm)
Weight: 0.62 lb. (280g)
Certifications: FCC, CE, IC