Alcorn REPRO24D Binloop Reproducer Firmware 1.76

Release Notes:

- Corrected a minor issue with non-volatile settings and reproducer identification

Installation Instructions:

1. Copy OS.NEW to the Compact Flash card.
2. Reset unit by turning it off, and then on again.
3. Wait for Update to complete. You will see the following LED sequence:
VERIFY FILE - Solid GREEN LED
ERASING FLASH - Solid RED LED
PROGRAMMING FLASH - Solid ORANGE LED
4. The firmware version on the reproducer can be read using the diagnostic version request in Binloop.exe.
NOTE: When the update is complete, the OS.NEW file will be renamed to OS.SAV so that the update does not repeat when the hardware is powered-up again. If you want to use a single flash card to update multiple units (for example, an entire Binloop cage), you can change the name of the OS.NEW file to FACTORY.NEW. The FACTORY.NEW file will perform an update just like OS.NEW, only it will not be renamed at the end of the update process. This means that after an update, you can remove the flash card from the product and insert it into another product to perform another update. This method will allow you to update an entire Binloop cage using a single card, without powering down the cage.

About Device Firmware:

Applying a newer firmware version than the one already installed on your unit can bring various enhancements, include workarounds for diverse problems encountered by the device, and improve or add newly developed features.

On the other hand, downgrading the firmware version can recover the device’s functionality in the event of a software update either turning up faulty or causing the unit’s overall performance to drop. However, bear in mind that applying an older firmware isn’t recommended and might not always be possible.

When it comes to the update steps, due to the large variety of devices and numerous ways for installing a new firmware, it is recommended that you carefully read and understand the upgrade steps, and consider applying a different firmware only when you have familiarized yourself with the update method.

As the installation process is most of the times quite risky, this step should be taken by users that have the ability to successfully complete the update; regular users may initiate it at their own risk. Moreover, it’s best that this task be performed in a steady power environment such as the one ensured by a UPS unit.

Therefore, if you consider applying this release, hit the download button, take into account all the aforementioned aspects, and update the device’s firmware. Also make sure you constantly check with our website to ensure that you don’t miss a single new release.