Installation Guide:
How to use AWDFLASH.EXE utility: This is a flash memory write/read utility.
IMPORTANT NOTE:
The AWDFLASH utility could not correctly run in windows (virtual 8086) MS-DOS mode. It must be proceeded with the following steps:
- Create a bootable system floppy diskette by typing "FORMAT A:/S" from the dos prompt under DOS6.XX or WINDOWS9X environment.
- Boot system with diskette.
- Then run the AWDFLASH utility.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- BIOS
- COMPATIBLE WITH:
- Windows All
- file size:
- 242 KB
- filename:
- P2e_V102slcp.zip