Fixes
1. Fixed issue where the hard disk drive may be enabled in suspend if the Wi-Fi Catcher switch is pressed.
2. Fixed issue where the system may hang in POST with certain USB microphones attached.
3. Fixed issue where boot order changes may not get saved if an Admin password is installed at the same time.
4. Fixed issue where TPM cannot be activated in Setup after it has been enabled.
5. Fixed issue where changes to the Setup integrated USB hub mode may not take effect until a cold boot.
Enhancements
1. Added support for Microsoft Windows Vista.
2. Added setup option to enable Serial ATA device-initiated power management.
3. Added DIMM part number and asset information to SMBIOS tables.
4. Increased amount of memory available for use when 4 GB of memory is installed.
1. Fixed issue where the hard disk drive may be enabled in suspend if the Wi-Fi Catcher switch is pressed.
2. Fixed issue where the system may hang in POST with certain USB microphones attached.
3. Fixed issue where boot order changes may not get saved if an Admin password is installed at the same time.
4. Fixed issue where TPM cannot be activated in Setup after it has been enabled.
5. Fixed issue where changes to the Setup integrated USB hub mode may not take effect until a cold boot.
Enhancements
1. Added support for Microsoft Windows Vista.
2. Added setup option to enable Serial ATA device-initiated power management.
3. Added DIMM part number and asset information to SMBIOS tables.
4. Increased amount of memory available for use when 4 GB of memory is installed.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- BIOS
- COMPATIBLE WITH:
- Windows NT
Windows 2K
Windows XP - file size:
- 953 KB
- filename:
- D820_A04.EXE