EVGA Z97 Classified BIOS 1.05

BIOS 1.05 Updates:
- Fixed USB device wake from S5
- Improved mouse compatibility
- Fix system reset when LAN disabled and BCLK set to 125
- Fix Boot fail when exit BIOS via ESC key
- Improved memory compatibility and performance
- Fix BCLK lock after change DIMM or CPU
- Fix PXE Boot
- Improve DVI>Analog compatibility
- Add CPU Voltage auto table by BCLK
- Improved overclocking

Windows Installation:

- Download the correct .zip for your motherboard
- First go into your BIOS and load defaults, save and exit
- Close all open programs.
- Go into the folder where you unzipped this package and update.bat
- Press Y to start the flash process
- DO NOT TURN OFF POWER OR RESET DURING THE FLASH PROCESS
- After the flashing is finished, the system will automatically shut down. Then power on again and go into BIOS to setup.
- NOTE: If flash box immediately closes after flash attempt, the flash may need to be ran from a CMD prompt with administrator privileges or DOS version.

BIOS Installation:

- Extract the contents of .zip file to USB flash drive (must be formatted as FAT32)
- Reboot the machine and go into the system BIOS
- From the BIOS, navigate to the Save & Exit tab and open "Select BIOS File."
- Select the .bin file you wish to flash.
- After the flashing is finished, shut the system down completely. Then power on again.
- After flashing verify that the correct flash was applied by checking the version number on the lower right corner of the BIOS screen.