Biostar p4tsep Bios 1.03f

Socket 478
Intel� Pentium 4 processor up to 3.06GHz(FSB533), 3.6GHz(FSB800) and Celeron Processor up to2.4GHz
800MHz system interface speed
4-Phase Power Design for Optimal Performance

CHIPSET
Intel 875P/ICH5R

MEMORY
Dual Channel 128bit (See Dual Channel Guidelines)
ECC Support
4 x 184-pin DDR SDRAM DIMM
Maximum 4GB
PC3200/2700 DDR SDRAM

Dual Channel Guidelines
Matched DIMM configuration in each channel
Same Density (128MB, 256MB, 512MB, 1GB, etc.)
Same DRAM technology(128M-bit, 256M-bit, or 512M-bit)
Same DRAM bus width (x8 or x16)
Both either single-sided or dual-sided
Matched in both Channel A and Channel B memory channels
Populate symmetrical memory slots

INTEGRATED AUDIO
C-Media CMI9739A 6-Channel AC��97 CODEC

WLAN
RTL 8180 BIOSTAR AirLink� RF Module

Gigabit LAN
Intel 82547EI
Supports Communicationn Streaming Architecture Interface(CSA)
Direct Connect to the MCH of North Bridge (Intel 875P)

IDE RAID
VIA VT 6410
Supports RAID 0, RAID 1, RAID 0 1 Level and JBOD
Dual Channel Master Mode PCI Supporting Four Enhanced IDE Devices

SATA RAID
ICH5R/Intel RAID Technology
Supports RAID 0(Striping)
Data Transfer Rates up to 1.5GB/s
Hard Drives Can Read and Write Data in Parallel to Enhance Performance

IEEE1394a
VIA VT6307
Supports 2 Ports with Transfer up to 400mbps

Optimal platform performance with Dual Channel, DDR400, matched DIMMs
Fully loaded configurations can be single or double sided DIMMs
Lightly loaded configurations need to be double sided DIMMs
When not using DDR400, best performance obtained with
Symmetrical DIMM population and matched double-sided DIMMs
Lightly loaded configuration

1 x PCI
1 x AGP
1 x CNR
1 x WLAN Module Slot