Adaptec ASC-1045 HBA BIOS 4.0.1.2

Fixes:
- Resolved multiple issues with AFU Verify and Display functions.
- AFU Verify function changes
- The message displayed during the reading of the flash content was changed to a single line.
- When the content of the flash is different then the file, it will now display the
checksum for the image in flash and the file for comparison.
  - The full flash build number is now displayed properly when a Verify is completed.
- Increased response time of the Verify function.
- AFU Display function changes:
- The full flash build number is now displayed properly.
- Increased response time of the Display function.
- Resolved an issue with being unable to boot SLES 10 SP2 OS from attached SAS drives when a SATA CD was attached to the same controller and set as the primary boot device with media inserted.  
- Resolved an issue preventing Windows installation from seeing devices installed in an Enhance Technology RS8SS enclosure. During a Windows installation, after the driver was loaded (by pressing F6) Windows would respond with: "Setup either detected multiple disks in your machine that are indistinguishable or detected Raw disks. Setup has corrected the problem but a reboot is required. Setup cannot continue". Rebooting system would bring back to the same error. This error has been corrected and no reboot is required.
- Resolved an issue where the BIOS would stop responding and displayed "Adaptec HBA Reset failure.Please reboot" error when no LUNs were assigned.