Focusrite RedNet 6 Ethernet Audio Interface Firmware 582

Fixes following bugs:

- 241741 – When RedNet 6 SRC was clocked to Word Clock input, corrupt MADI data could be transmitted
- 220335 – RedNet 6 does not retain clock source selection on power cycle

To update RedNet 6 firmware, follow these instructions:

- Extract the firmware file from "RedNet 6 Firmware 582.zip"
- Launch RedNet Control
- Right click on the virtual RedNet 6 device panel
- Select Firmware Update...
- Choose the extracted file: "RedNet 6 Firmware 582.dnt"
- Wait for firmware update process to complete. Do not switch off or disconnect the device.
- After firmware flashing is complete, the unit will reboot
- The unit will now be updated and ready to use 

About Sound Card Firmware:

Apply this firmware version to your sound card, and the device can receive improved audio quality, fixes for various issues, enhanced features, as well as several other changes that might boost the unit's performance, stability and compatibility.

Before you even consider upgrading your sound card, make sure the modifications that are to be made through the present release suit your needs. Don't get the downloadable package otherwise.

Because of the large number of models and manufacturers, as well as the different methods for updating the audio component, it is highly recommended that you read and understand the installation steps before you apply the new firmware.

In addition to that, it would be best if you perform the update in a steady power environment, such as the one ensured by a UPS unit.

Therefore, if this firmware satisfies your needs, get the desired version, and install it to your system; if not, check with our website as often as possible so that you don't miss the update that will improve your device.