Atomos Shogun Flame Recorder Firmware 7.3

BUG FIXES:

- Fixed an occasional issue where audio recorded on channels 5 to 8 was corrupted when received from some equipment.
- Fixed an issue where audio noise was introduced from sources such as Nikon D800 and Microsoft XBOX

Analog audio embedding on loop out signal

- Turn on “Embed Analog audio” in the Audio menu.
- Select which channel to embed by clicking on the “A” button.
- The embedded channel will replace the existing channel on the loop out.
- Audio meters will continue to show the input signal.

HDR metadata embedded in .mov files

- Added correct metadata to .mov files for Rec.2100 modes (PQ and HLG) when AtomHDR monitor mode is enabled.

HLG support for Panasonic GH5 and Sony FS5

- Access via the monitor mode AtomHDR menu

HDR support for Red Log3G10

- Access via the monitor mode AtomHDR menu

Added the option to pause video during slow motion playback

- Secure Erase is supported on selected media for: Sandisk Extreme Pro, Atomos branded Gtech media, Atomos branded Angelbird media, Sony SV-GS series 

Firmware Update Tutorial:

- Download and unzip the file.
- Copy the file onto a recommended, formatted driver, using the docking station included with your recorder.
- Insert the drive into the Atomos recorder while it’s off.
- Power up the Atomos recorder.
- The screen will show flashing lines of color. This is normal - DO NOT power off!
- Updating will take a few minutes.
- Once completed, the Atomos recorder will power down.
- Power up the Atomos recorder again.
- Check Menu > Product Info > AtomOS Version. This should match the version you have just downloaded.
- Enjoy your updated Atomos recorder !

Firmware Recovery Tutorial:

- Power down the Atomos recorder (Hold power button for 4 seconds).
- Hold down the power button for 10 seconds approximately.
- You will see the “Firmware Update Failed” screen.
- Insert your HDD / SSD.
- The install process will begin and the screen will show flashing lines of color. This is normal - DO NOT power off !
- Once completed, the Atomos recorder will power down.
- Enjoy your updated Atomos recorder !

About Video Recorder Adapter Updates:

Applying a new firmware package on your Video Recorder adapter should improve overall performance and stability, fix various issues encountered with the device, or add support for newly developed features.

The Video Recorder adapter should be carefully upgraded by a power user (that is to say, someone who has the know-how to successfully complete the process), but it can also be performed by an average user at his or her own risk.

Either way, given the fact that each producer has their own method for installing a new firmware, and that every device has a particular way to enter the update mode, you must not consider upgrading the adapter's software until you have read and thoroughly understood the installation steps.

As a rule, said steps shouldn't pose too much of a challenge because manufacturers strive to make them as easy as possible. As with everything else, exceptions do occur, and users should be prepared for them.

Usually, you should transfer the compatible firmware to the Recorder through a USB cable or a memory card, and afterwards enter update mode from the unit's setup menu or through a specific power-on method.

With this in mind, if you intend to apply this release, make sure the package is compatible with your Video Recorder and that it brings about the changes you want or require; hit the download button and apply the new firmware.

Don't forget to regularly check with our website so that you don't miss any updates.