Ubiquiti locoM2 Access Point Firmware 6.3.2.33267

Fixes:

- Fix infctld crashing in some cases.
- Fix signal reporting instability in some cases just after connection initialized.
- Fix regression: restored min. power to -4 for some AirGrid M5 HP devices.
- Fix stability improvement after taking support file.
- Fix WebUI: Unable to import RSA SSH key since v6.3.0.

Improvements:

- Improved UNMS support.
- Improved remote IPv4 address reporting for mixed mode.
- Changed factory defaults IP configuration to DHCP client with fallback to 192.168.1.20

Security fixes:

- Improved security of default NAT firewall rules. 

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.