Ubiquiti locoM2 Access Point Firmware 6.3.0.33226

Major changes:

- TFTP recovery responds to discovery requests and takes address from DHCP.

Regulatory updates:

- Update frequency plan for Indonesia according to PM 1-2019: removed 2474MHz.

Security Fixes:

- WebUI: Fix various CSRF & XSS vulnerabilities reported via our Bug Bounty program.
- Also block access via IPv6 when block management access is enabled.
- PPPD patched for CVE-2020-8597.
- Dnsmasq patched for CVE-2019-14513.

Fixes:

- Fix airMAX AC >=v8.7.0 access point missing LAST IP for airMAX M clients.
- Fix ATPC for AirGrid M5 HP: minimal power was too low.
- Extend compatible antenna list for ISOSTATION M5.
- Update self-signed HTTPS certificate generation rules to match macOS v10.15 and iOS v13 requirements.
- WebUI doesn't load if custom HTTP port 81 is configured.

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.