Ubiquiti USG Access Point Firmware 4.4.29.5124210

Changes since 4.4.28 as follows:

- Fix crash in speed test encountered when a speed test server refused or abandoned a connection. The same underlying problem exhibited itself in multiple completely different ways. For some, USG went to disconnected in the controller. In other cases, USG was re-adopting repeatedly, or showed up an inform error. 
- Restore logging of specific error conditions from controller. Recent USG, UAP and USW firmware versions would log "decrypt error" for all error responses from controller.
- Fix image/css path issue introduced in 4.4.28 in USG's local web UI.
- Upgrade Suricata to 4.0.5. Don't mind the "4.0.0-dev" version string you might see in the logs, it's 4.0.5 and future versions will show the actual version in place of that instead.

Upgrade WARNING:

- If using a VLAN tag on WAN, and on a controller version including port remapping (5.8.7 and newer), you should not upgrade to this version until upgrading to controller 5.8.12, 5.9.3, or newer. For that circumstance, USG must be provisioned by the newer controller version (which will happen automatically post-controller upgrade) before upgrading to any firmware version including port remapping support. 
- If you have GeoIP enabled and are not yet on firmware 4.4.18 or newer, disable it first, then upgrade USG, then enable it again. The configuration has changed in a way that limited unstable controller and previous firmware version combinations could result in an invalid configuration on the new firmware versions. In that circumstance, if the upgrade is performed with GeoIP enabled, the system will have to be reset to factory defaults post-upgrade.

Downgrade WARNING: 

- If you upgrade to any version supporting DPI without offload, disable offload (or enable IDS/IPS) and enable DPI, you cannot downgrade to a version that does not support DPI without offload. Either disable DPI, or enable hardware offload (or disable IDS/IPS), before downgrading. Otherwise you'll have to reset to factory defaults post-downgrade and adopt again.   

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.